Home Garden
WHERE DO I CHANGE THE FREQUENCY ON A CRAFTMADE CEILING FAN?
Question : WHERE DO I CHANGE THE FREQUENCY ON A CRAFTMADE CEILING FAN?
MODEL fr52. iNSTRUCTIONS SAY LOWER PART OF FAN ON RECEIVING MODULE. NOTHING IN INSTRUCTIONS IS CALLED RECEIVING MODULE.
we have a TCS-Plus remote control switch, no hard-wired switch. I and my neighbor interfere with each other’s switch, so I need to change the frequency on both my switch and my fan/light. I found the frequency switches on my remote switch, but not on the fan.
craftmade fans
Best answer:
Answer by mike p
If your talking about speed change, speed control is done with capacitors and selecting different windings on the motor wiring.
The remote control (receiving module) can and will be in either of two places.
It wil be either above or below the fan motor.
I believe both covers are called bonnets.
If there is a housing above the fan motor, the mounting area, there will be one or more screws that you can loosen and turn the whole housing counter clockwise (looking up) then that should drop down revealing the module, there will be three or more multiple position switches that you can set the code with.
The second place is under, directly in the center of the fan blades, where the pull switches are. Here you may have to completely remove the screws to get the cover off, and the code setting procedure will be the same.
Just make sure the codes are identical on both the fan and the remote