Archive for September, 2010

split air conditioner is gaining popularity over window type mainly because this type of air conditioning everywhere easily installed without requirement of a window and has to be a beautiful, elegant look. They have a low cost of installation if the cost of capital is low.

Although it may be a small increase in power consumption of a split type window type, the cost of running virtually the same for both air conditioning and there is virtually no difference in efficiency.

Unlike window type, a distribution system has condensing unit outside. This leads to a great advantage in a fraction of a kind that the noise level remains low, as the loud part, kept the compressor outside. Wall evaporation remains in the house. kept the elegant style to the wall and the connecting lines from outside increases the aesthetic sense of the piece to a large extent. It is not necessary to make a provision in the window of your room or renovate your existing windows for the installation of a split air conditioner, window type contrast.

In a split air conditioner, the indoor unit draws air from the room and throws it into the room after cooling and humidity of him, while the outdoor unit, the heat in the atmosphere. Before choosing an air conditioner of split type, it is important that you have informed some basic ideas in the following paragraphs.

We know that our body temperature 99 degrees Fahrenheit (37 degrees Celsius). A comfortable room, it is necessary to a temperature between 70-79 degrees F have (21 to 26 degrees Celsius) with a relative humidity of 20-50%.

It is important that the heat load of the space that is used as an alternating current of low-capacity not in a position to the room and a turnover of more capacity to allow the moist chamber can be disposed of cool calculation.

An air conditioner’s heating and cooling capabilities are ranked in watts or kilowatts. Normally, a bedroom with two occupants outweighs 50 British Thermal Units (BTU) of heat per hour per square meter of surface area. One kilowatt equivalent to 3400 BTU per hour. This will mean a 15 meter x 15 meter size of the rooms, air conditioning with a capacity of 11 250 BTU (15 feet x 15 feet x 50 BTU / houtr) are required. This number must be 600 BTU / h for each person and 1000 are added BTU / h for each unit.

Try also to avoid three-phase connection is difficult to maintain and expensive to install and go for the stage-name. Normally, the air conditioning efficiency by energy rating (EER), the relationship between cooling performance and energy consumption of the rule of thumb is measured, the higher the better ERA is cooling.

The isolation room should be good to have a good air conditioning. As more and more air flow cooling is best, but be sure to purchase a system at a greater rate of removal of moisture. Check whether there is a low noise level below 50 decibels for your air conditioning.

Rotary compressors are recommended usually have other types of compressors. These compressors have fewer moving parts than reciprocating compressors.

In the type of facilities split air conditioning automatic is available, the automatic timer, automatic sleep mode, auto restart, remote control, automatic self-diagnostic testing, filter cleaning alarm / LED, automatic switching of dehumidification, should be named, etc., but a few.

Be sure to check the above features before you buy a stylish and elegant split air into your living room or dining room or conference room in your office. Some of the most popular models on the market are Toshiba, Daikin, Hitachi, LG and Ogeneral.