Do it yourself: change a sink faucet

Replacing a sink faucet is one of the most common problems people face now and sanitation can again, and some do-it-yourself tactics in this regard to save your hard-earned money. If you think you can not with a wrench, and sanitation is not your favorite type of work, then get help from professional installers. But if you want to try it yourself, here is a detailed how-to for changing a sink Wasserhahn.Obwohl one would think of buying a new faucet is the first step, I put it next to the dismantling of the old. The first thing you need to do is check your tools so you do not get angry to find it in the middle of the job. Among the various tools that you would have to appropriate wrench, WD40, and Zange.Nun locate the shut-off valve that is normally under the sink. If you can not find it there, then go from your home to find him, it could be found at the water meter. Use WD40 to spray the valves. This makes them more relaxed, which makes the task a little easier. If you have difficulty grasping it occurs, try wearing gloves or a cloth in order to better handle them. In addition, using an appropriate formula to separate the hot and cold water lines. When you finish these are sure that the water supply is by trying, turn on the tap. Some water that was left inside the pipeline may come first but the flow would stop then. Under these measures would ensure that you are not soaked in water when removing the end Wasserhahn.Überprüfen Now other links to the hardness, if you have such a hard to find some spray WD40 on the connections to solve them. Grab your pliers and remove the nuts under the sink that connect to the faucet and the sink. Now, take the faucet and clean the rust from Spüle.Was you need is in addition to other appropriate tap. Before you go to the hardware store, you should do some research on water taps. Otherwise you will be overwhelmed with the myriad types of valves – in different size, shape, style, weight, etc. So the best thing to do to take the dismantling of old faucet, if you forget the size. You can also manually made measurements in order to facilitate the selection. Choose whichever style suits you but make sure that the size would fit. Almost all the faucets have a manual, as it is to be installed, said. Read these instructions to avoid any questions later. Place each piece on its place as directed in the manual and use the wrench and put on other tools, plumbing connection points. Just be careful not to tighten points. Check all connections and make sure that each brought even the smallest piece in its place. Now turn on the shutoff valves and check through the lines, especially the connection points for any leakage. If there is a leak at one point, you can dismantle and re-join that one and pull a bit more until the leak stops. The manual back in the middle of the work, if you face any problem. The entire process of changing the valve may seem complicated to some. In case you are one of them, simply call your local installer and let him work in a professional manner.