One of the bath time consuming jobs for a plumber is that of a complete toilet installation. While there are good for plumbers and certainly have a lot of experience under his belt, has there are many do-it-yourself, take up the challenge. And if you ask me, it’s not really as difficult as it seems, especially if you know what each part and where it would go. This article guides you through a complete replacement toilet is half in a few easy to remember Schritte.Der simplicity discussed here, only the toilets with a separate tank that is installed above the toilet bowl arrived. If you have not received instructions from the manufacturer, this would be the time to go it thoroughly. And it is always better, an illustrated description of the parts haben.Zunächst you turn off the water supply to the tank and flush it twice to ensure that all the water goes down the drain. To promote safety, use a sponge to water remaining in the tank or bowl you trocken.Öffnen the nuts and bolts that connected the tank to the bowl and the water will be. In doing this, it will be easy to remove the tank. In case there is an arc between the tank and the bowl, you have to be removed first. Then open the bolts that are used around the tank must be mounted on the walls. Do this step with great care and hold the container in the hands of you, so that they do not fall when have abgelöst.Jetzt from the wall remove the bowl, which is fixed to the floor with a few screws and nuts. These screws are usually hidden under caps, you can remove by using a screwdriver under the lid and slide it in the upward direction. The screwdriver can be packaged in foil, so it does not damage the smooth surface of the toilet bowl. After removing the cap and bolts, the toilet bowl in their place, because securing a seal with the ground. Rock It So go slowly and forth and the seal would break eventually. Now you can bowl, wherever you want, but it would be a little weightlifting auszuüben.Sobald the shell away from the office is to open the toilet in the flange. Shove some old, abandoned gas channel in such clothing would not escape into your house; This also assures that no removable parts are from the flange. Now put the new toilet and get ready to install it, you just have everything back in its place in the reverse Reihenfolge.Nehmen the clothes from the flange and apply some plumbers putty to the bottom of the bowl, where they come into contact with the ground come. Now place the bowl so that it would just come out over the flange. The screws will not fit in their place when the bowl instead of injustice. Once you have correctly put in the position to ensure that it is level with the ground. Next, place the nuts and bolts where they belong, and appropriate dress. Put the caps on the screws and viola – the new toilet is now in perfect shape. Next to the tank line to the wall and everything was in place in exact reverse order that you removed before. Now wash your hands, clean up, and look forward to your new toilet!